Jump to content
Sign in to follow this  
Auriel22

.gob sel not acting as intended.

Recommended Posts

     Hey, everyone. As the title says, I've observed that .gob sel is acting much differently than before, in a way that I don't believe is intentional. .gob sel is supposed to select the target nearest to you, but as I build with these building tiles, I find that this is seemingly no longer the case.

https://gyazo.com/1f4baf3b716f7f91c33598416b647b47 - Here, you can see where I have a macro for .gob sel that I use to select nearest. I am also standing in what should be the very center of the tile.

https://gyazo.com/129d370617f2006627e699a0b2c3d659 - Even more strange, I find that if I move a ways away from it, to the edge of another tile diagonal to it, .gob sel will select the last tile.

https://gyazo.com/73440212f303e5701f9da3618b78d6f9 - In fact, .gob sel seems to just act completely random. There's nothing that seems methodical about it at all.

     ...I'm afraid that I have no clue what's going on here. It's definitely thrown a fairly large wrench into the building project I was working on, though. I see this being a little problematic. I'm not sure if it's of any importance, but I should note that doing .gob sel without a macro will yield identical results.

Share this post


Link to post
Share on other sites

Gentle bump - has anyone else experienced this as of late? I think there'd be a bit more outrage over gob selection not selecting nearby objects.

Share this post


Link to post
Share on other sites
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×