Northman 18 Posted December 9, 2019 Hello, The command .ph forge npc display allows your NPC to have multiple display ID's. Useful but sadly it does not work anymore. I have used this command in the past by placing a comma after typing each display ID I want registered on my NPC. I could then go around spawning the NPC in its available display ID's... Now if you try to apply this command on your NPC the NPC simply morphs into the blue/white box and you lose the NPC. Even if you want to morph your NPC back to its original display ID it will still remain a blue/white box. Can this please be fixed? If there is anything required from me hit me up on Discord @Turkish Dad#6579 Thank you for reading! ♥ Share this post Link to post Share on other sites
Gardener 126 Posted December 10, 2019 We're aware of this issue, there is a workaround for it at the moment where if you use the following: .phase forge npc display 418 418 418 418 It should give the NPC a proper display, albeit limited to the one displayID. Share this post Link to post Share on other sites