SyvenOG 0 Posted February 12, 2022 Type: Waypoints - NPC Behavior After using the command on the NPC .wa stop The NPC stops for an amount of time then at random after some time starts walking again. Steps to reproduce: 1. Place any NPC in your phase and set up a multiple of waypoints for the NPC to follow then use the command. 2. .wa start to make the NPC start walking. 3. Type .wa stop to stop the NPC 4. Wait from 2 to 5+ minutes. Expected result: The NPC should permanently stop and not walk along the waypoints when stopped. Observed result: Instead the NPC stops only for a short amount of time and resumes walking after a couple of minutes. Reproduction rate: Seems 100% Share this post Link to post Share on other sites
Razmataz 14 Posted July 11, 2022 figured it out. should be fixed soon. figured it out. should be Share this post Link to post Share on other sites